If you have a thread break or your bobbin runs out, you can move your start point to begin stitching in a spot other than the beginning of the design.
- Press Pause.
- Your motors are locked, so the machine will not move.
- Select Pro-Stitcher tab.
- Press New Start & End on the ribbon.
- Touch Auto in the Start column twice.
- This will move the start point (the green circle with an X in the middle) to exactly where your needle is.
- To adjust the precise position of the start point: Tap the arrow pointing up at the bottom of the slide bar OR top of the slide bar, move the green bullet back to where you want to start stitching again.
- Press Motors on ribbon to unlock.
- Now you can move your machine to rethread or change your bobbin.
- Select Tie off on resume and Pull up on resume if desired, and then press Resume.
- The machine will start stitching where you set the new start point.